Voyager V6-3.0L VIN 3 (2000)
5. Disengage cable end from bellcrank assembly.
6. Remove latch handle from sliding door.
7. Remove push-in fastener holding cable end to latch handle.
Fig. 27
8. Disengage cable casing end from latch handle (Fig. 27).
9. Disengage cable end from latch handle.
10. Remove handle from vehicle.
INSTALLATION
1. Place inside latch handle in position on vehicle.
2. Engage cable end into latch handle.
3. Engage cable casing end into latch handle.
4. Install push-in fastener to hold cable into latch handle.
5. Place latch handle in position on sliding door.
6. Install screw to hold top of inside latch handle to sliding door.
7. Install screws to hold bottom of inside latch handle to sliding door.
8. Engage cable end into bellcrank assembly.
9. Engage clip to hold cable end into bellcrank assembly.
10. Verify sliding door operation. Adjust as necessary.
11. Install sliding door trim panel.
Inside Latch Handle Bellcrank
INSIDE LATCH HANDLE BELLCRANK
REMOVAL
1. Remove sliding door trim panel.
2. Peel watershield away from adhesive around perimeter of inner door panel as necessary to gain access to latch bellcrank.
3. Remove latch/lock control cover.
4. Disengage clip holding inside release bellcrank link to latch/lock control.
5. Remove bellcrank link from latch/lock control.
6. Disengage clip holding release handle latch cable to bellcrank.
7. Remove cable from bellcrank.
