Voyager V6-3.0L VIN 3 (2000)
7. Place seat belt anchor in position on floor so webbing is pointed rearward and slightly outboard.
8. Install bolt attaching lower seat belt anchor to floor. Tighten all seat belt bolts to 39 N.m (29 ft.lbs.) torque.
9. Verify that seat belt anchor does not interfere with seat track travel.
B-Pillar Upper Trim
B-PILLAR UPPER TRIM
REMOVAL
1. Remove bolt attaching lower seat belt anchor to floor.
2. Lower shoulder belt height adjuster to the bottom of travel.
3. Remove shoulder belt turning loop from height adjuster.
4. Use a Snap-on® Trim Pad Remover tool (A179A), or equivalent, and remove shoulder belt height adjuster knob.
5. Remove shoulder belt bezel from trim cover.
6. Remove screw attaching trim cover to B-pillar from inside bezel cavity.
7. Disengage hidden clips attaching trim cover to B-pillar.
Fig. 4
8. Remove B-pillar trim cover from vehicle (Fig. 4)
INSTALLATION
1. Insert seat belt through B-pillar trim and web guide.
2. Place B-pillar trim cover in position on vehicle.
3. Engage hidden clips attaching trim cover B-pillar.
4. Install screw attaching trim cover to B-pillar inside bezel cavity.
5. Install shoulder belt bezel into trim cover.
6. Install height adjuster knob.
7. Install shoulder belt turning loop onto height adjuster. Tighten bolt to 39 N.m (29 ft.lbs.) torque.
8. Place seat anchor in position on floor so webbing is pointed rearward and slightly outboard.
9. Install bolt attaching lower seat belt anchor floor. Tighten seat belt bolt to 39 N.m (29 ft.lbs.) torque.
C-Pillar Trim
C-PILLAR TRIM
REMOVAL
1. Remove quarter trim bolster.
