Voyager V6-3.0L VIN 3 (2000)
Master Cylinder Mounting To Vacuum Booster
7. Remove the 2 nuts attaching the master cylinder assembly to the brake vacuum booster.
8. Slide master cylinder assembly straight out of the power brake vacuum booster.
CAUTION: The master cylinder is used to create the seal for holding vacuum in the power brake vacuum booster. The vacuum seal/boot on the
master cylinder MUST be replaced whenever the master cylinder is removed from the power brake vacuum booster.
9. Remove the vacuum seal located on the mounting flange of the master cylinder. The vacuum seal is removed from the master cylinder by carefully
pulling it away from the master cylinder. Do not attempt to pry the seal off the master cylinder by inserting a sharp tool between seal and master
cylinder casting.
BLEEDING MASTER CYLINDER
CAUTION: When clamping master cylinder in vise, only clamp master cylinder by its mounting flange, do not clamp on primary piston, seal or body of
master cylinder.
Master Cylinder Mounted In Vise
1. Clamp the master cylinder in a vise using only the mounting Range .
NOTE: Two different size bleeding tubes are used depending on which type of master cylinder the vehicle is equipped with. Vehicles equipped
with traction control use a center port master cylinder with a larger diameter brake tube. Vehicles not equipped with traction control use a
compensating port master cylinder using a standard 3/16 inch diameter brake tube. Be sure the correct size bleeding tubes are used when bleeding
the master cylinder.
