Voyager V6-3.0L VIN 3 (2000)
5. Install the required fitting from Pressure Test Fittings, Special Tool 6833 into the inlet port of the proportioning valve assembly, from which the
chassis brake line was removed. Install the removed chassis brake line into the Pressure Test Fitting . Install the required fitting from Pressure Test
Fittings, Special Tool 6833 into the required outlet port of the proportioning valve. Install the required fitting from Pressure Test Fittings, Special
Tool 6833 into the required outlet port of the proportioning valve. Then install the removed chassis brake line into the Pressure Test Fitting.
6. Install a pressure gauge from Gauge Set, Special Tool C-4007-A into each pressure test fitting. Bleed air out of hose from pressure test fittings to
pressure gauges, at the pressure gauges. Then bleed air out of the brake line being tested, at that rear wheel cylinder.
