Voyager V6-3.0L VIN 3 (2000)
Fig. 91
4. Remove rear oil seal retainer and seal as assembly (Fig. 91).
5. Release mono-block main bearing cap bolts evenly. Remove lower bearing shells and identify for reassembly.
6. Lift out crankshaft and remove upper thrust washers from each side of number three main bearing in the crankcase (Fig. 89).
INSTALLATION
Fig. 92
1. Install upper main bearing shells making certain oil holes are in alignment, and bearing tabs seat in block tabs. All upper bearings have oil grooves
(Fig. 92).
2. THRUST BEARINGS. Crankshaft thrust bearings (washers) are installed at journal #3 separately from the radial bearings. Thrust bearings shown
in (Fig. 92) are different, one has end positioning tabs, while the other is plain. One pair of each thrust washers are installed into the block and one
pair into the main bearing cap (Fig. 92).
