Voyager V6-3.0L VIN 3 (2000)
26. Remove lower half of the Panel door.
Lower Floor Door
27. Remove lower half of the Floor door.
REASSEMBLY
For reassembly of the distribution housing, reverse the above procedures.
To reassemble the distribution housing actuator gears, an assembly procedure of the gears and cam is necessary.
Actuator Gears Alignment Procedure
1. Install lower FLOOR door actuator gear to housing. Match master spline of FLOOR door actuator gear to master spline on door.
2. Install cam wheel. Align cam wheel track to FLOOR door actuator gear.
3. Align cam wheel slot with the post on the distribution housing marked "1".
4. Install PANEL door actuator gear. Align master spline of PANEL door actuator gear to master spline on PANEL door. Position actuator gear
within cam wheel track.
5. Install DEFROST door actuator gear to housing. Match master spline of DEFROST door actuator to master spline on DEFROST door. Position
actuator gear within cam wheel track.
6. Reinstall housing in vehicle.
7. Perform the HVAC control Calibration Diagnostic and Cooldown test. See: Control Assembly/Testing and Inspection
