Voyager V6-3.0L VIN 3 (2000)
designations follows:
-
AW - All wheel drive harness
-
B - Body or EDW harness
-
C - Dome harness
-
D - Door harness
-
E - Engine harness
-
F - Fuel rail harness
-
H - Heated seat harness
-
J - Jumper harness
-
L - Liftgate harness
-
P - Instrument panel harness
-
RC - Radio control harness
-
RS - Radiator fan harness
-
S - Seat harness
-
T - Trailer tow harness
When looking at a splice reference the alpha code for what harness the splice is located in will come first, then an S to indicate a splice, and finally the
splice number. An example of this would be ESO2.
-
E - Indicates splice is in the engine harness
-
S - Indicates a splice
-
02 - Indicates what splice it is in the harness
Electrostatic Discharge (ESD) Sensitive Devices
Electrostatic Discharge Symbol
All ESD sensitive components are solid state and a symbol is used to indicate this. When handling any component with this symbol comply with the
following procedures to reduce the possibility of electrostatic charge build up on the body and inadvertent discharge into the component. If it is not
known whether the part is ESD sensitive, assume that it is.
1. Always touch a known good ground before handling the part. This should be repeated while handling the part and more frequently after sliding
across a seat, sitting down from a standing position, or walking a distance.
2. Avoid touching electrical terminals of the part, unless instructed to do so by a written procedure.
3. When using a voltmeter, be sure to connect the ground lead first.
4. Do not remove the part from its protective packing until it is time to install the part.
5. Before removing the part from its package, ground the package to a known good ground on the vehicle.
Notes, Cautions and Warnings
Additional important information is presented in three ways: Notes, Cautions, and Warnings.
NOTES are used to help describe how switches or components operate to complete a particular circuit. They are also used to indicate different
conditions that may appear on the vehicle. For example, an up-to and after condition.
CAUTIONS are used to indicate information that could prevent making an error that may damage the vehicle.
WARNINGS provide information to prevent personal injury and vehicle damage. Below is a list of general warnings that should be followed any time a
vehicle is being serviced.
WARNING:
