Voyager V6-3.0L VIN 3 (2000)
14. Remove the steering knuckle to ball joint stud, clamping nut and boltfrom the steering knuckle.
15. Using a pry bar, separate steering knuckle from ball joint stud. NOTE: Use caution when separating ball joint stud from steering knuckle. so ball
joint seal does not Pet cut.
NOTE: Care must be taken not to separate the inner C/V joint during this operation. Do not allow driveshaft to hang by inner C/V joint after
removing outer CN Joint from the hub/bearing assembly in steering knuckle, end of driveshaft must be supported.