Voyager V6-3.3L VIN 3 Flex Fuel (2003)
Sliding Door Handle: Service and Repair
Outside Handle
OUTSIDE HANDLE
REMOVAL
1. Remove sliding door trim panel.
2. Remove sliding door stop bumper.
3. Peel watershield away from adhesive around perimeter of inner door panel as necessary to access outside release handle fasteners.
4. Disengage clip attaching outside door handle linkage to door cable.
5. Remove linkage from outside door handle.
Fig. 24
6. Remove three nuts attaching outside door handle to outer door panel (Fig. 24).
7. Remove outside door handle from vehicle.
INSTALLATION
1. Position outside door handle on vehicle.
2. Install nuts attaching outside door handle to outer door panel.
3. Engage clip attaching linkage to outside door handle.
4. Engage rigging cam to latch/lock control mechanism.
5. Move clip on latch/lock control to bottom of slot and engage linkage to latch/lock control.
6. Verify sliding door operation. Adjust as necessary.
7. Place the watershield into position and press securely to adhesive making sure to properly route wiring and linkages.
8. Install sliding door stop bumper.
9. Install sliding door trim panel.
