Voyager V6-3.3L VIN 3 Flex Fuel (2003)
NOTE: The chassis brake tube attachment locations to the HCU, are marked on the bottom of the ICU mounting bracket.
3. Install the 6 chassis brake tubes into their correct port locations on the HCU valve block as shown.. Tighten the tube nuts to a torque of 17 Nm
(145 in. lbs.).
NOTE: Before installing the 24-way connector in the CAB, be sure the seal is properly installed in the connector.
4. Install the 24-way connector on the CAB using the following procedure. Position the 24-way connector in the socket of the CAB and carefully
push it down as far as possible. When connector is fully seated by hand into the CAB socket, push in the connector lock. This will pull the
connector into the socket of the CAB and lock it in the installed position.
NOTE: The CAB wiring harness must be clipped to the ICU mounting bracket. This will ensure the wiring harness is properly routed and does
not contact the brake tubes or the body of the vehicle.
5. Clip the cab wiring harness to the ICU mounting bracket.
6. Install the routing clips on the brake tubes.
7. Lower the vehicle.
8. Connect negative cable back on negative post of the battery.
9. Bleed the base and ABS hydraulic systems.
10. Road test vehicle to ensure proper operation of the base and antilock brake systems.