Voyager V6-3.3L VIN 3 Flex Fuel (2003)
10. On both sides of vehicle, remove nut attaching outer tie rod end to steering knuckle. Remove nut by holding tie rod end stud with a socket while
loosening and removing nut with wrench.
11. Remove bolts fastening leak detection pump to cradle crossmember reinforcement.
12. Remove both outer tie rods from steering knuckles, using Puller, Special Tool C-3894-A.
13. Remove the lower control arm rear bushing retainer bolts located on each side of each lower control arm rear bushing.
NOTE: The bolts fastening the cradle crossmember reinforcement are of two different thread sizes. Note the location of the various sizes.