Voyager V6-3.3L VIN 3 Flex Fuel (2003)
Shifter A/T: Service and Repair
GEAR SHIFT LEVER
REMOVAL
1. Remove the knee blocker.
2. Remove the knee blocker reinforcement.
3. Remove the upper and lower shrouds.
4. Remove the cluster trim bezel.
5. Remove the fixed shroud from the column.
6. Disconnect the electrical connector to the BTSI.
7. Remove the two screws securing the BTSI to the steering column. (Fig. 33)
8. Disconnect the SKIM electrical wire connector.
9. Remove the SKIM from the steering column.
10. Disconnect the autostick wiring connector (if equipped with autostick).
11. Disconnect the shifter cable at the shifter.
12. Remove the three screws securing the shifter to the steering column. (Fig. 34)
13. Remove the shift lever from the column.
INSTALLATION
1. Install the shifter cable to the shifter.
2. Install the three screws securing the shifter to the steering column.
3. Install the shifter cable at the handle.
4. Install the SKIM to the steering column.
5. Reconnect the SKIM electrical wire connector.
6. Reconnect the autostick wiring connector (if equipped with autostick).
7. Install the two screws securing the BTSI to the steering column.
