Voyager V6-3.3L VIN 3 Flex Fuel (2003)
2. Install the outer CV joint assembly onto the interconnecting shaft. Joint is installed on interconnecting shaft, by pushing interconnecting shaft into
outer CV joint, until retaining ring is seated in groove on interconnecting shaft (Fig. 29). Verify that the retaining ring is fully seated into groove
on interconnecting shaft.
3. Distribute 1/2 the amount of grease provided in seal boot service package (DO NOT USE ANY OTHER TYPE OF GREASE) into outer CV joint
assembly housing. Put the remaining amount into the sealing boot.
4. Install outer CV joint seal boot retaining clamp, onto interconnecting shaft. Install replacement outer CV joint sealing boot onto interconnecting
shaft. Outer CV joint seal boot MUST be positioned on interconnecting shaft, so that only the thinnest (sight) groove on interconnecting shaft is
visible (Fig. 30).
