Voyager V6-3.3L VIN 3 Flex Fuel (2003)
6. Remove three (3) TCM-to-rail screws and remove TCM from vehicle (Fig. 17).
INSTALLATION
NOTE: If transmission control module is being replaced with a new or replacement unit, the Pinion Factor and Quick Learn procedures must be
performed. (Refer to ELECTRICAL/ELECTRONIC CONTROL MODULES/TRANSMISSION CONTROL MODULE - STANDARD
PROCEDURE) (Refer to ELECTRICAL/ELECTRONIC CONTROL MODULES/ TRANSMISSION CONTROL MODULE - STANDARD
PROCEDURE).
Fig.18 Transmission Control Module Removal/Installation
1. Install TCM into position (Fig. 18). Install three (3) screws and torque to 3 Nm (30 in. lbs.).
Fig.19 Transmission Control Module 60-Way Connector
2. Install TCM harness 60-way connector (Fig. 19) and torque to 4 Nm (35 in. lbs.).
3. Install splash shield into position with fasteners.
4. Install left front wheel/tire assembly.
