Voyager V6-3.3L VIN R (2000)
3. Using a trim stick, pry lower edge of HVAC bezel away from headlining (Fig. 13) .
4. Remove louver from vehicle.
INSTALLATION
1. Place bezel in position in HVAC duct opening.
2. Push inward on bezel until clips snap in place. Verify that all four clips have been engaged to the bezel and that the bezel is flush to the headlining
3. Position HVAC louver to bezel.
4. Snap both ends of the louver into HVAC bezel.
Sliding Door Sill Plate
SLIDING DOOR SILL PLATE
REMOVAL
1. Disengage hidden clips holding sill plate to sliding door opening sill.
Fig. 16
2. Disengage hooks holding outside edge of sill plate to door sill (Fig. 16) .
3. Remove sill plate from vehicle.
INSTALLATION
1. Place sill plate in position on vehicle.
2. Engage hooks to hold outside edge of sill plate to door sill.
3. Align guide pins to holes in door sill.
4. Engage hidden clips to hold sill plate to sliding door opening sill.
