Voyager V6-3.3L VIN R (2000)
Control Assembly: Service and Repair
Radio Bezel and HVAC Control Replacement
REMOVAL
1. Remove convenience bin - cup holder. Refer to Convenience Bin - Cup Holder Removal and Installation procedure.
2. Insert the trim stick (special tool # C-4755) between access cover and radio bezel, above convenience bin - cup holder.
Convenience Bin Access Cover
3. Carefully pry the access cover from the instrument panel.
4. Separate the access cover from the vehicle.
5. Remove convenience bin - cup holder track. Refer to Convenience Bin - Cup Holder Track Removal and Installation procedures.
Radio Bezel and HVAC Control
6. Remove the attaching screws holding bottom of the bezel to instrument panel.
7. Remove the attaching screws holding top of the bezel to the instrument panel.
8. Remove the bezel from the instrument panel.
9. Disconnect the wire connector from back of the rear blower switch, if equipped.
10. Disconnect the wire connector from the back of the HVAC Control.
11. Remove the bezel.
