Lanos S Hatchback L4-1.6L DOHC D-TEC MFI (1999)
Temperature Sensor (Gauge): Service and Repair
ENGINE COOLANT TEMPERATURE SENSOR
Removal Procedure
1. Disconnect the negative battery table.
2. Drain the coolant below the engine coolant temperature sensor level.
3. Disconnect the electrical connector from the engine coolant temperature sensor.
4. Remove the temperature sensor from the cylinder head.
Installation Procedure
1. Install the engine coolant temperature sensor into the threaded hole in the cylinder head.
Tighten the engine coolant temperature sensor (DOHC) to 20 Nm (15 ft. lbs.).
2. Connect the electrical connector to the engine coolant temperature sensor.
3. Refill the coolant system. Refer to "Draining and Refilling the Cooling System" in this section.
4. Connect the negative battery cable.
