Lanos S Hatchback L4-1.6L DOHC D-TEC MFI (1999)
8. Remove the module from the housing. If necessary, insert the blade of a screwdriver into the slot near the end of the circuitboard, and use the
screwdriver as a lever to free the circuitboard from its connector inside the housing.
Installation Procedure
1. Install the lamp driver module into the housing. Press the card into the connector inside the module, and close the cover. Be sure to orient the card
the same as the card you removed. There is a slot that serves as a keyway to allow entry one way only. Look into the housing to see where the slot
has to be.
2. Secure the lamp driver module to the Antilock Brake System (ABS) harness with electrical tape.
3. If the tie strap for the wire harness was cut during the removal procedure, use a new tie strap to prevent movement of the wire harness.
4. Install the Electronic Brake Control Module (EBCM) mounting bracket.
5. Install the EBCM.
6. Install the right-side kick panel.
7. Connect the negative battery cable.
