Lanos S Sedan L4-1.6L DOHC D-TEC MFI (2001)
Notice: Care must be taken to prevent brake fluid from contacting any painted surface to prevent damage to the paint finish.
10. After all the air has been removed at the forward connection(s), bleed the master cylinder at the rear (cowl) connection(s) in the same manner as
with the front connections.
Important: For vehicles equipped with a non-antilock braking system, non-ABS, the bleeding sequence is as follows: right rear, left front, left
rear, and right front.
11. Attach a transparent tube over the valve. Allow the tube to hang submerged in brake fluid in a transparent container.
12. Slowly push and hold the brake pedal one time.
13. Remove the bleeder cap and loosen the bleeder screw to purge the air from the cylinder.
14. Tighten the bleeder screw.
-
Tighten the bleeder screw to 9 Nm (80 inch lbs.).
