Lanos S Sedan L4-1.6L DOHC D-TEC MFI (2001)
Installation Procedure
1. Install the exhaust manifold gasket.
2. Install the exhaust manifold.
3. Install the exhaust manifold retaining nuts and tighten them in the sequence shown.
-
Tighten the exhaust manifold retaining nuts 25 Nm (18 ft. lbs.).
4. Install the auxiliary catalytic converter nuts to the exhaust manifold.
-
Tighten the auxiliary catalytic converter-to-exhaust manifold nuts to 40 Nm (30 ft. lbs.).
5. Install the exhaust manifold heat shield.
6. Install the exhaust manifold heat shield bolts.
-
Tighten the exhaust manifold heat shield bolts to 15 Nm (11 ft. lbs.).
7. Connect the pre-converter oxygen sensor connector.
