Lanos S Sedan L4-1.6L DOHC D-TEC MFI (2001)
9. Remove the liquid condenser pipe connector block bolt at the receiver-dryer.
10. Remove the liquid condenser pipe from the vehicle.
11. Cap the opening at the receiver-dryer to prevent contamination.
INSTALLATION PROCEDURE
1. Position the liquid condenser pipe section into the vehicle.
2. Install a new O-ring on the connector block at the receiver-dryer.
3. Install a new O-ring at the liquid condenser to evaporator plate pipe connector block.
4. Install the bolt securing the liquid condenser pipe connector block to the receiver-dryer.
Tighten
Tighten the liquid condenser pipe connector block-to-receiver-dryer bolt to 14 N.m (10 lb-ft).