Lanos SE Hatchback L4-1.6L DOHC D-TEC MFI (1999)
2. Remove the plugs from the brake pipes and connect them to the hydraulic modulator. Secure each pipe with a pipe nut.
Tighten
Tighten the brake pipe nuts to 16 Nm (12 ft. lbs.).
3. Install the motor pack and solenoid electrical connectors.
IMPORTANT: Make sure that the solenoid electrical connectors are correctly installed.
4. Reconnect the negative battery cable.
5. Bleed the brake system. See: Brake Bleeding
Gear Cover
Disassembly Procedure
1. Remove the hydraulic modulator/motor pack assembly from the vehicle. See: Hydraulic Modulator/Motor Pack Assembly
2. Remove the Torx head screws.
3. Lift the gear cover from the hydraulic modulator/motor pack assembly.
Assembly Procedure