Lanos SE Hatchback L4-1.6L DOHC D-TEC MFI (1999)
1. Place the control arm bushing housing J-29376-A on the rear axle. Slide the puller bolt J-21474-19 through the thrust washer J-1474-19, the
control arm bushing plate J-29376-7, the rear control arm bushing, the control arm bushing remover/installer J-29376-6A and into the nut
J-21474-18.
2. Install the rear axle bushing by turning the nut J-21474-18 and counterholding the puller bolt J-21474-19.
3. Be sure the bushing angle is 40 to 50 degrees to the axis of the rear angle.
4. Install the rear axle. See: Axle Beam
5. Lower the vehicle.