Lanos SX Sedan L4-1.6L DOHC D-TEC MFI (2001)
Receiver Dryer: Service and Repair
REMOVAL PROCEDURE
1. Disconnect the negative battery cable.
2. Recover the refrigerant. Refer to "Discharging, Adding Oil, Evacuating, and Charging Procedures for A/C System".
3. Remove the nut and the bolt that secure the connector block to the top of the receiver-dryer.
4. Cap the open connections to prevent contamination.
5. Remove the bolt that secures the receiver-dryer band clamp.
6. Remove the receiver-dryer.
7. Drain the oil from the receiver-dryer into a container. Measure the amount of oil drained from the receiver-dryer and then discard this used oil.
INSTALLATION PROCEDURE
IMPORTANT: Do not uncap the new unit until lust prior to installation.
1. Add oil to the new receiver-dryer. Use the exact amount of oil that you drained from the receiver-dryer.
2. Install new O-rings in the seal area recess of the new receiver-dryer.