Lanos SX Sedan L4-1.6L DOHC D-TEC MFI (2001)
3. Connect both tie rods to the steering gear by threading the inner tie rod bolts through the inner tie rod plate, the tie rods, and the center housing
cover washers into the rack guide. Install a new lock plate.
Tighten the inner tie rod bolts to 90 Nm (66 ft. lbs.).
4. Seat the dash seal and attach the coupling flange to the steering gear. Secure the coupling flange assembly with the top pinch bolt on the coupling
flange assembly.
Tighten the coupling flange pinch bolt to 22 Nm (16 ft. lbs.).
5. Tighten all the steering gear retaining bracket nuts and bolts.
Tighten the steering gear retaining bracket nuts and bolts to 38 Nm (28 ft. lbs.).
6. Check that the steering gear has remained in the straight-ahead position.
7. Connect negative battery cable.
8. For left-hand drive vehicles, reconnect the coolant surge tank with the attaching nuts.
Tighten the coolant surge tank attaching nuts to 4 Nm (35 inch lbs.).
Disassembly and Reassembly
RACK AND PINION
-
Tools Required
-
KM-J-26610 Installer KM-472 Wrench
Disassembly Procedure
1. Remove the rack and pinion steering assembly from the vehicle.