Leganza CDX L4-2.2L DOHC D-TEC MFI (1999)
11. After the air has been bled at the top connection, bleed the master cylinder at the side connection using the same sequence as with the top
connection.
12. Attach a transparent tube over the rear bleeder valve at the right rear caliper. Allow the tube to hang submerged in the brake fluid in a transparent
container. (After the right rear caliper is bled in the following steps, use this procedure at the left front, the left rear, and the right front bleeder
valves.)
13. Slowly push and hold the brake pedal. Avoid rapid pumping of the brake pedal.
14. While the brake pedal is pushed down, loosen the bleeder valve to purge the air from the caliper.
15. After the air bubbles have escaped into the container of brake fluid, slightly tighten the rear bleeder valve.
16. Slowly release the brake pedal. Wait 15 seconds before proceeding with the next step.
NOTICE: Keep brake fluid away from painted surfaces because brake fluid will damage the paint finish.
