Leganza CDX L4-2.2L DOHC D-TEC MFI (1999)
Brake Master Cylinder: Service and Repair
Disassembly and Reassembly
Disassembly Procedure
1. Remove the master cylinder.
2. Remove the brake fluid reservoir.
3. Remove the screw from the cylinder.
NOTICE: When removing the retaining ring, avoid damaging the piston or the cylinder wall.
4. Remove and discard the retaining ring from the cylinder body by pressing the hollow shaft and using needle-nosed pliers to grasp and squeeze the
retaining ring.
5. Remove the washer and the primary piston assembly.
6. Carefully remove the secondary piston assembly, including the spring, from the master cylinder bore.
Assembly Procedure
NOTICE: Do not use abrasives in the master cylinder bore. Abrasives can damage the bore.
