Leganza CDX L4-2.2L DOHC D-TEC MFI (1999)
Tighten the pulse pickup sensor disc to 13 Nm (115 inch lbs.).
3. Install the crankshaft.
4. Install the lower crankshaft bearings in the bearing caps.
5. Inspect the crankshaft end play with the crankshaft bearings installed.
6. Check for permissible crankshaft end play. Refer to Crankshaft, Engine; Specifications.
7. With the crankshaft mounted on the front and rear crankshaft bearings, check the middle crankshaft journal for permissible out-of-round (runout).
Refer to Crankshaft, Engine; Specifications.
Important: Grease the crankshaft journals and lubricate the crankshaft bearings slightly so that the plastic gauging thread does not tear when the
crankshaft bearing caps are removed.
8. Inspect all of the crankshaft bearing clearances using a commercially available plastic gauging (ductile plastic threads).
9. Cut the plastic gauging threads to the length of the bearing width. Lay them axially between the crankshaft journals and the crankshaft bearings.
