Leganza CDX L4-2.2L DOHC D-TEC MFI (1999)
8. Inspect the piston for fit to the connecting rod.
9. Inspect the engine block deck surface for flatness using a straight edge and a feeler gauge. Refer to Cylinder Block Assembly; Specifications.
10. Inspect the bearing bore for concentricity and alignment using cylinder bore check gauge J-8087. Refer to Connecting Rod, Engine;
Specifications. If the bearing bore is beyond specifications, replace the engine block.
11. Inspect the engine block cylinder bore for wear, runout, ridging, and taper using a bore gauge. Refer to Cylinder Block Assembly; Specifications.
12. Inspect the engine block cylinder bore for glazing. Lightly hone the cylinder bore as necessary.
INSTALLATION PROCEDURE
Important: For ease of installation of the piston pin, the connecting rod should be heated to 280°C (536° F). Heat the upper connecting rod only.
Use commercial thermocooler material to determine the correct temperature. When the thermocooler material changes from black to green, the
temperature is correct for installation.
1. Align the notch on the piston and the connecting rod so that the proper sides will be facing the front of the engine.
2. Install the piston pin guide through the piston and the connecting rod.
3. Coat the piston pin with clean oil.
4. Install the piston pin into the opposite side of the piston.
