Leganza CDX L4-2.2L DOHC D-TEC MFI (1999)
1. Insert the CKP sensor into the engine block.
2. Install the CKP sensor retaining bolt.
Tighten: Tighten the crankshaft position sensor retaining bolt to 10 Nm (89 lb-in).
3. Connect the CKP sensor connector.
4. Install the accessory mounting bracket with the bolts.
Tighten: Tighten the accessory mounting bracket bolts to 35 Nm (26 lb.ft).
5. Install the rear A/C mounting bracket.
Tighten: Tighten the rear A/C mounting bracket bolts to 35 Nm (26 lb.ft).
6. Install the A/C compressor. Refer to Automatic Temperature Control Heating, Ventilation, and Air Conditioning System.
7. Install the power steering pump. Refer to Power Steering Pump.
8. Connect the negative battery cable.
