Leganza CDX L4-2.2L DOHC D-TEC MFI (1999)
Throttle Body: Service and Repair
THROTTLE BODY
Removal Procedure
1. Disconnect the negative battery cable.
2. Disconnect the intake air temperature (IAT) sensor connector.
3. Disconnect the breather hose from the valve cover.
4. Remove the air intake tube.
5. Disconnect the throttle cables by opening the throttle and moving the cable through the release slot.
6. Disconnect the vacuum hoses from the throttle body.
7. Disconnect the throttle position (TP) sensor and the idle air control valve connectors.
8. Disconnect the coolant hoses from the throttle body.
9. Remove the throttle body retaining nuts.
NOTE: Cover the opening of the intake manifold after removing the throttle body assembly. This will prevent any objects or debris from entering
the engine which may cause damage.