Leganza CDX L4-2.2L DOHC D-TEC MFI (1999)
Window Regulator: Service and Repair
(Front Door Shown, Rear Door Similar)
Removal Procedure
1. Disconnect the negative battery cable.
2. Remove the door glass.
3. Disconnect the electrical connector.
4. Remove the nuts and the window regulator.
Installation Procedure
NOTE: Dissimilar metals in direct contact with each other may corrode rapidly. Make sure to use the correct fasteners to prevent premature
corrosion.
1. Install the window regulator with the nuts.
Tighten
Tighten the window regulator nuts to 7 Nm (62 lb.in).
2. Connect the electrical connector.
3. Install the door glass.
4. Connect the negative battery cable.