Leganza SE L4-2.2L DOHC D-TEC MFI (2001)
Seat Track: Service and Repair
Power Driver Seat Slide Assembly
Removal Procedure
1. Remove the driver seat.
2. Remove the front seat cushion.
3. Disconnect the electrical connector.
4. Remove the bolts, the nuts, the screws, and the slide assembly.
Installation Procedure
NOTE: Dissimilar metals in direct contact with each other may corrode rapidly. Make sure to use the correct fasteners to prevent premature corrosion.
1. Install the slide assembly with the bolts, the nuts, and the screws.
Tighten
Tighten the slide assembly bolts to 25 N.m (18 lb-ft). Tighten the slide assembly nuts to 15 N.m (11 lb-ft). Tighten the slide assembly screws to
10 N.m (89 lb-in).
2. Connect the electrical connector.
3. Install the front seat cushion.
4. Install the driver seat.