Leganza SE L4-2.2L DOHC D-TEC MFI (2001)
7. Remove the bolts and the washers which secure the complete parking brake lever assembly to the underbody.
Notice: The parking brake switch should be replaced if the BRAKE warning light in the instrument panel cluster did not glow when the parking
brake was applied with the ignition ON.
8. If necessary, remove the parking brake switch, attached to the parking brake lever assembly by a small screw, and remove the switch.
Installation Procedure
Notice: If the parking brake lever is bent or damaged, replace the complete parking brake lever assembly.
1. If necessary, fasten the parking brake switch to the parking brake lever assembly with the screw.
Tighten the parking brake switch-to-parking brake lever screw to 4 Nm (35 inch lbs.).
