Leganza SE L4-2.2L DOHC D-TEC MFI (2001)
11. Install the throttle cable bracket bolts.
-
Tighten the throttle cable bracket bolts to 8 Nm (71 inch lbs.).
12. Connect the throttle cable to the intake manifold and the throttle body.
13. Connect all the previously disconnected vacuum lines.
14. Connect the MAP sensor connector.
15. Connect the coolant hoses to the throttle body.
16. Connect the IAC valve connector.
17. Connect the TPS connector.
18. Position the power steering hose in place and install the clamp bolt.
-
Tighten the power steering hose clamp bolt to 8 Nm (71 inch lbs.).
19. Connect the air intake tube to the throttle body.
20. Connect the IAT sensor connector.
21. Connect the EVAP emission canister purge solenoid at the intake manifold and tighten the bracket bolt.
