Leganza SE L4-2.2L DOHC D-TEC MFI (2001)
Crankshaft Position Sensor: Service and Repair
Removal Procedure
1. Disconnect the negative battery cable.
2. Remove the power steering pump, if equipped. Refer to Power Steering Pump.
3. Remove the A/C compressor. Refer to Automatic Temperature Control Heating, Ventilation, and Air Conditioning System.
4. Remove the rear A/C compressor mounting bracket bolts and the rear A/C compressor mounting bracket.
5. Remove the accessory mounting bracket by removing the bolts.
6. Disconnect the crankshaft position (CKP) sensor connector.
7. Remove the CKP sensor retaining bolt.
8. Gently rotate and remove the CKP sensor from the engine block.
Installation Procedure
