Leganza SE L4-2.2L DOHC D-TEC MFI (2001)
1. Install the PNP switch, then install the stud bolt, bolt and nut and washer hand tight.
-
Tighten the retaining nut to 53 - 71 ft. lbs. (6 - 8 Nm).
2. Place the shift control lever in the Neutral (N) position.
3. Align the neutral basic line on the PNP switch with the flat on the manual detent lever.
-
Tighten the stud bolt to 14 - 22 ft. lbs. (20 - 29 Nm).
-
Tighten the bolt to 7 - 11 ft. lbs. (10 - 16 Nm).
4. Position the fluid filler tube bracket on the stud bolt and the shift control cable linkage on the manual detent lever stud. Install the shift control
cable linkage and fluid filler tube bracket retaining nuts.
-
Tighten the shift control cable linkage-retaining nut to 15 Nm (11 ft. lbs.).
-
Tighten the fluid filler tube bracket retaining nut to 16 Nm (12 ft. lbs.).
