Leganza SE Steering Gear Removal and Installation
4. Install the dust boot.
5. Install the cylinder end dust boot retaining clamps with the installer KM-J-22610.
6. Install the tie rod end boot retaining clamps.
7. Reposition the adjusting nut to the marks on the inner tie rod and install the outer tie rod by twisting it onto the inner tie rod.
8. Perform a front toe adjustment.
9. Tighten the adjusting nut.
Tighten the outer tie rod adjusting nut to 64 Nm (47 ft. lbs.).
10. Install the rack bearing assembly into the rack and pinion steering assembly.
11. Install the valve and pinion assembly into the rack and pinion steering assembly.
