Leganza SE L4-2.2L DOHC D-TEC MFI (2001)
7. Remove the control arm front nuts and the bolts.
8. Remove the control arm rear bushing clamp bolts and the clamps.
9. Remove the control arms.
Assembly Procedure
Important: The weight of the vehicle must be supported by the control arms before the stabilizer link-to-control arm nut, the stabilizer
shaft-to-stabilizer link nut and the control arm front nut and the rear bolts are tightened. This can be done by lowering the vehicle onto jackstands
under the control arms.
1. Install the control arms.
2. Install the control arm rear bushing clamps and the clamp bolts. Do not tighten.