Leganza SE L4-2.2L DOHC D-TEC MFI (2001)
3. Connect the drive axle to the front wheel hub.
4. Connect the ball joint to the knuckle assembly.
5. Install the ball joint pinch bolt and the nut.
Tighten the ball joint pinch bolt nut to 90 Nm (66 ft. lbs.).
6. Connect the ABS speed sensor electrical connection.
7. Connect the outer tie rod to the knuckle assembly.
8. Install the brake caliper onto the rotor and the brake line onto the strut.
9. Install the washer and the caulking nut onto the axle shaft.
Tighten the drive axle-to-hub caulking nut to 180 Nm (133 ft. lbs.). Loosen the nut, then retighten it to 50 degrees plus 60 degrees.
10. Install the dust cap.
11. Install the wheel.
12. Lower the vehicle.
Disassembly and Reassembly
