Leganza SE L4-2.2L DOHC D-TEC MFI (2001)
Notice: Discard the PCS O-ring.
12. Remove the retaining bolt and the PCS.
Notice: Discard the lockup solenoid O-ring.
13. Remove the retaining bolt and the lockup solenoid.
Installation Procedure
Notice: Lubricate the SST, SS2, PCS and lockup solenoid O-rings with TOTAL FLUID HX.
1. Install new O-rings on shift solenoid 1 (SS1), shift solenoid 2 (SS2), the PCS and the lockup solenoid.
2. Install SST, SS2, the PCS and the lockup solenoid into the valve body, then install the solenoid retaining bolts and clamp and the valve body bolt.
-
Tighten the SST, SS2, the PCS and the lockup solenoid retaining bolts to 53 - 62 inch lbs. (6 - 7 Nm).
-
Tighten the valve body bolt to 53 - 62 inch lbs. (6 - 7 Nm).
3. Connect the SST, SS2, the PCS and the lockup solenoid electrical connectors.
Notice: Remove the old gasket material from the valve body cover and mating surface of the transaxle.