Leganza SE L4-2.2L DOHC D-TEC MFI (2001)
Transmission Speed Sensor: Service and Repair
Output Shaft Speed (OSS) Sensor
Removal Procedure
1. Disconnect the output shaft speed (OSS) sensor electrical connector.
2. Using the appropriate Torx (R) fastener tool, remove the OSS sensor retaining bolt, then grasp the body of the OSS sensor and remove it from the
transaxle.
Installation Procedure
Notice: Lubricate the O-ring with TOTAL FLUID HX.
1. Install a new O-ring on the output shaft speed (OSS) sensor.