Leganza SX L4-2.2L DOHC D-TEC MFI (1999)
3. Disconnect the brake line at the top of the master cylinder.
4. Allow the brake fluid to fill the master cylinder until it begins to flow from the port.
5. Reconnect the brake line at the top of the master cylinder.
6. Slowly push and hold the brake pedal.
7. While the brake pedal is pushed down, loosen the brake fitting at the top of the master cylinder to purge the air from the cylinder.
8. Slightly tighten the brake fitting. Then release the brake pedal slowly. Wait 15 seconds before continuing with the next step.
9. Repeat Steps 6-8 until all of the air is removed from the master cylinder bore.
10. Tighten the brake line fitting.
Tighten
Tighten the brake line fitting to 16 Nm (12 ft. lbs.).
