Front Brake Caliper Service and Repair: Leganza SX L4-22L DOHC D-TEC MFI (1999)
IMPORTANT: Do not use a hone or any other procedure to remove material from the caliper bore or the piston.
1. Clean all parts in denatured alcohol or brake fluid. Dry the parts with unlubricated, compressed air and blow out all passages in the housing and
the bleeder valve.
2. Inspect the piston and caliper for scoring, nicks, or corrosion. Replace any components which show these conditions.
3. Install the bleeder valve.
4. Lubricate a new piston inner seal with brake fluid.
5. Install the piston inner seal into the groove in the caliper bore.
6. Install the piston dust seal in its groove.
7. Lubricate the piston with brake fluid.
6. Push the piston inward until it is properly seated. Make sure that the dust seal is in the correct groove in the piston and the caliper.
9. Reinstall the caliper.
10. Bleed the brake system. See: Brake Bleeding
