Nubira CDX Sedan L4-2.0L DOHC D-TEC MFI (1999)
Installation Procedure
1. Lubricate new seals with clean brake fluid. Install the seals into the cylinder body.
2. Install the reservoir on the master cylinder body.
3. For vehicles with the manual transaxle, connect the clip to the clutch hose connection to the master cylinder.
4. Add brake fluid.
5. Raise and suitably support the vehicle.
6. Bleed the braking system. See: Brake Bleeding
7. Bleed the clutch master cylinder.
8. Lower the vehicle.
9. Connect the reservoir electrical connector.