Nubira CDX Wagon L4-2.0L DOHC D-TEC MFI (2000)
5. Slide the new dust cover onto the dust cover notches.
6. Insert the new lever and the dust cover assembly into the backing plate.
7. Secure the new dust cover retainer using pop rivets.
8. Lubricate the actuation cavity and the tappet with grease. Ensure that the internal bore of the cavity is covered with grease.
9. Secure the splash shield and the backplate to the steering knuckle with the bolts, and secure the parking brake shoe hold-down spring assembly
with the screw.
Tighten the splash shield bolts to 35 Nm (26 ft. lbs.).
Tighten the parking brake shoe hold-down spring assembly screw to 3.5 Nm (31 inch lbs.)
10. Connect the new parking brake adjustment screw to the new adjustment nut. Tighten the nut to where it meets the screw, and then back off
one-quarter of a turn.
