Nubira CDX Wagon L4-2.0L DOHC D-TEC MFI (2000)
5. Install the booster and the mounting nuts to the dash panel.
Tighten the booster-to-dash panel nuts to 22 Nm (16 ft. lbs.).
6. Insert the shaft and the rubber O-ring into the power booster.
7. Connect the master cylinder to the booster.
8. Connect the brake line fittings to the hydraulic modulator, if applicable.
Tighten the brake line fittings to 16 Nm (12 ft. lbs.).
9. Install the new vacuum hose to the booster.
10. Install the hose clamps on the vacuum hose, and snap the vacuum hose in the revolving clip.
11. Install the pushrod pin to the brake pedal bracket assembly and connect the clip and the spring.
12. Install the brake stoplamp switch onto the brake pedal bracket.
