Nubira CDX Wagon L4-2.0L DOHC D-TEC MFI (2000)
Intake Manifold: Service and Repair
Removal Procedure
1. Remove the fuel pump fuse.
2. Start the engine. After it stalls, crank the engine for 10 seconds to rid the fuel system of fuel pressure.
3. Disconnect the negative battery cable.
4. Disconnect the evaporative emission canister purge solenoid from the intake manifold and loosen the bracket bolt.
5. Drain the engine coolant. Refer to Coolant; Service and Repair.
6. Disconnect the intake air temperature sensor connector.
7. Disconnect the air intake tube from the throttle body
8. Disconnect the idle air control valve connector.
9. Disconnect the throttle position sensor connector.
10. Disconnect the manifold absolute pressure (MAP) sensor connector.
11. Disconnect the coolant hoses at the throttle body.
12. Disconnect all of the necessary vacuum hoses, including the vacuum hose at the fuel pressure regulator and the brake booster vacuum hose at the
