Nubira CDX Wagon L4-2.0L DOHC D-TEC MFI (2000)
Heater Control Valve Cable: Service and Repair
NOTE: The Position of Heating, Ventilation and Air Conditioning (HVAC) Controller moved upward, but the On-Vehicle Service is similar.
Removal
1. Disconnect the negative battery cable.
2. Remove the glove box. Refer to Instrumentation/Driver Information
3. Slide the cable eyelet off the post on the temperature door lever.
4. Disconnect the cable retainer from the blower housing.
5. Remove the audio system trim plate.
6. Remove the four controller retaining screws.
7. Pull out the controller to provide clearance for removal of the temperature control cable.
8. Disconnect the temperature control cable eyelet from the post on the controller.
9. Snap the cable housing connector out of the slide position on the controller.
Installation