Nubira CDX Wagon L4-2.0L DOHC D-TEC MFI (2000)
Power Transistor HVAC: Service and Repair
Removal
1. Disconnect the negative battery cable.
2. Disconnect the electrical connector at the resistor.
3. Remove the screws from the resistor.
4. Remove the resistor from the heater/air distributor case assembly by gently pulling the resistor downward.
Installation
1. Install the new resistor into the heater/air distributor case assembly with the screws.
Tighten
Tighten the blower motor resistor screws to 6 N.m (53 lb-in).
2. Connect the electrical connector at the resistor.
3. Connect the negative battery cable.
4. Confirm the proper performance of the blower,
